Draining a Waterbed

There are generally three safe and acceptable ways to drain a watermattress, all of which require a simple garden hose. The length of hose should be no longer than necessary to get the water away from the building by about 10 feet or so. Too long a hose will create excess drag, and can slow the draining process, in addition to causing extra work.

The first order of business when you begin to drain your waterbed is to always unplug your waterbed heater. This is critical because when the heater no longer has a sufficient depth of water, it will overheat and eventually burn itself up, along with your liner and watermattress. This can be dangerous and costly.

Next you will need to remove all the air bubbles that have accumulated inside the mattress, also known as "burping" your waterbed. This is easily done by gently sliding a broom stick (or any similarly shaped device) with gentle, downward pressure, across the top surface of the vinyl, toward the uncapped valve, allowing any trapped gasses to vent out of the watermattress. This is also a critical step to removing as much water as possible. Remember, that last ten gallons is the most difficult to remove because a vacuum is created as the bed empties out, and any air present inside will negate the vacuum, and make the mattress very heavy. So be sure to remove all the air bubbles before proceeding.

The first method of draining is to use a venturi pump. This is the T-shaped plastic fitting found in a waterbed fill and drain kit. Most reputable waterbed dealers will provide this with the sale of a waterbed, and they should have come with instructions. While these do work on free flow and semi-waveless water mattresses, they are not recommended to drain an ultra-waveless mattress. This is because they do not provide a strong vacuum that is needed in order to drain them enough to be picked up. These pumps rely on water pressure and gravity. They are only effective with the water flowing downhill, and with strong water pressure. The tap water must be kept running until the mattress is empty. This is the most inefficent and time consuming method. If you live in a basement, it may be your only choice, unless you can get your hands on an electric pump.

An electric pump is usually the fastest method. How fast is determined by how powerful your pump is, and whether the water is flowing up or downhill. Most will take 60-90 minuites. This is the best way to drain an ultra waveless watermattress. If you live in an apartment building, place the hose deep into your toilet bowl, and close the lid before starting. Most pumps will need to be primed (filled with water) in order to get started. This method, of course, will require electricity.

The siphon method will require only a hose. A male hose adapter, which also comes with a fill and drain kit, is helpful, but not necessary. Following the above instructions, next, place the male end of the hose into the valve of the waterbed. The other end of the hose needs to be placed as low as possible, in relation to the mattress. The more vertical drop, the faster the bed will drain. Next step is to suck on the lower end of the hose to start the water flowing. Once it begins to flow downhill, it will continue to do so until there is no more water left. For the squeamish, a wet-vac can be used to start the siphon.

Whichever draining method you choose, it is also important that you replace the plug and cap quickly after removing the hose from the watermattress, preserving the vacuum. Do not allow it to back fill with air. This will ensure that the fiberfill inside a waveless mattress will not shift, and bunch up into a big lump. This will be the subject of my next blog; Fibershift.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: